Electronics Forums > Lowrance Forum

Down Image disappeared

(1/2) > >>

phopkins38:
I have 2 HDS 7 Gen 2 with the LSS 2 mounted.One at the bow and one in the console. I had to do a factory reset and my Down Image screen capability went away and I cannot seem to get it back. I have sonar and side imaging. I use to have all three screens on the structure selection. I followed the install instructions again but no luck. Any help would be greatly appreciated.

JackJ:
Have you checked for firmware updates since you did that?  Maybe that will help.

Curt:
@Eric Low You run Lowrance units. Any ideas on this one?

Eric Low:
It has been a few years since I had those units. Make sure you install the correct transducer I believe 800/400/83 hz. Sounds like it is just picking up 83. Do you have down scan on the TM or are the units linked? Neither unit works?

JackJ:
Here you go... 

You have to reselect your tranducer type

Navigation

[0] Message Index

[#] Next page