Down Image disappeared
by phopkins38 on 16 Mar, 2016 22:59
I have 2 HDS 7 Gen 2 with the LSS 2 mounted.One at the bow and one in the console. I had to do a factory reset and my Down Image screen capability went away and I cannot seem to get it back. I have sonar and side imaging. I use to have all three screens on the structure selection. I followed the install instructions again but no luck. Any help would be greatly appreciated.
Reply #1
by JackJ on 17 Mar, 2016 10:12
Have you checked for firmware updates since you did that? Maybe that will help.
Reply #2
by Curt on 17 Mar, 2016 10:37
@Eric Low You run Lowrance units. Any ideas on this one?
Reply #3
by Eric Low on 17 Mar, 2016 15:26
It has been a few years since I had those units. Make sure you install the correct transducer I believe 800/400/83 hz. Sounds like it is just picking up 83. Do you have down scan on the TM or are the units linked? Neither unit works?
Reply #4
by JackJ on 17 Mar, 2016 17:00
Here you go...
You have to reselect your tranducer type
Reply #5
by Curt on 17 Mar, 2016 18:06
@phopkins38 The info above from Eric and Jack should help you!