Bass Boat Forums (by boat brand) > Nitro Bass Boats Forums
Finished up the front end
Jig Man:
I had a Lowrance Gen 2 touch 9 left over after my boat swap so I decided to use it on the Nitro. Also the foot pedal was too deep for my liking so I raised it.
This is how it came from the factory.
I took the tool holder and cup holder out and put in the bridge that I had Poly Fab make me.
I then attached the hds 9 gimble bracket.
I put in the foot pedal lift and mounted the hds 9. Now it will be used for chart and I can split the 12 with 2d and down scan.
Curt:
Cool setup! You lost your tool holder, but I guess you can't have everything! (nope)
Jig Man:
It has 2 other tool holders and 4 other cup holders so I think I'm good. Besides things blew out of that front one if they weren't strapped in.
Curt:
--- Quote from: Jig Man on August 02, 2016, 09:18:53 AM ---It has 2 other tool holders and 4 other cup holders so I think I'm good. Besides things blew out of that front one if they weren't strapped in.
--- End quote ---
I would say that two other tool holders and 4 other cup holders would be sufficient (giggle)
And I was wondering how secure stuff would be up there if the water was rough. All I could picture was a pair of needle nose pliers flying at you at 60 MPH :surprised: (fp)
fishon-son:
had a can of bang take my head off once.........i can say ouch......
Navigation
[0] Message Index
[#] Next page
Go to full version