Finished up the front end
Back-
I had a Lowrance Gen 2 touch 9 left over after my boat swap so I decided to use it on the Nitro. Also the foot pedal was too deep for my liking so I raised it.
This is how it came from the factory.
I took the tool holder and cup holder out and put in the bridge that I had Poly Fab make me.
I then attached the hds 9 gimble bracket.
I put in the foot pedal lift and mounted the hds 9. Now it will be used for chart and I can split the 12 with 2d and down scan.
-
Cool setup! You lost your tool holder, but I guess you can't have everything!
-
It has 2 other tool holders and 4 other cup holders so I think I'm good. Besides things blew out of that front one if they weren't strapped in.
-
It has 2 other tool holders and 4 other cup holders so I think I'm good. Besides things blew out of that front one if they weren't strapped in.
I would say that two other tool holders and 4 other cup holders would be sufficient
And I was wondering how secure stuff would be up there if the water was rough. All I could picture was a pair of needle nose pliers flying at you at 60 MPH
-
had a can of bang take my head off once.........i can say ouch......
-
It had a bungie to hold stuff in place. Things blew out on the way to the lake and were scattered around the deck when I didn't bungie them in. I won't miss it. My wife and I are going to run down to Table Rock this morning to see if I have everything adjusted to suit me.
-
looks great nice job
