Outboard Motor Forums (by brand) > Evinrude/Johnson Outboards

If you have any Johnny/Rude issues I'll try and answer them for ya!

<< < (2/3) > >>

bscravens:
87 GT150...runs great especially wide open!

chico1:
I have a 94 gt150 vro. Has hole in cylinder block. What other motors can I put on this drive setup

Curt:
@ChampioNman You've got questions!  (giggle)

ChampioNman:
The  GT 150's long run ended in 1991 so you don't have a 1994. You can have another power head installed on the mid section or you can install any cross flow head on it you do need to check about needing to install a different adapter plate to make it work. If you are talking about replacing the entire motor you can install any John/Rude up to 1996 after that you would need a wiring harness adapter as they changed the harness in 1996. The control cables will be fine.

Curt:
Thanks @ChampioNman  :thumbup:

@chico1 here's your answer  :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page