what products are u using? you may have to be a little more aggressive w/ the compound, but not too much or you'll start exposing flakes - not goodI used the Meguire’s 3-part fiberglass/gelcoat restoration kit.
Check out http://protecproducts.com/Interesting. Thanks Curt. Virtually the same boat he used in the video and he wetsanded it, even though the actual Ranger manual says not to.
Joe's stuff is some of the best on the market!
@Basscat1
he wetsanded it, even though the actual Ranger manual says not to.
I believe it, as it was my initial instinct to do this as well. The question is really how low of a grit to start - 1000? To keep it at a safe but effective level.he wetsanded it, even though the actual Ranger manual says not to.
I've heard of a lot of guys who wet sand boats when the finish is really bad. @Hydeshydro @Matt@Fractures and @Basscat1 all do this, I believe.
I believe it, as it was my initial instinct to do this as well. The question is really how low of a grit to start - 1000? To keep it at a safe but effective level.
Also, the way it's labeled, is it a second interior light for different compartments, kinda implied by the ones to the left for 2 bilge pumps which is a Ranger standard.Thanks all. The upper left switch allows power to the surface temp switch. There is only one bulge pump that runs off the lower-left switch. I need to get uber the dash to see what is hooked up to the mystery switch, if anything.