Nitro Z bow/trolling motor tray tool/cup holder

[Rhino81]

Have a new unused Nitro Z bow/trolling motor tool and cup holder. 

It wouldn’t work for my setup.

Part Number: 188896
Part Quantity: 1
Part Description : Cup/tool holder for nitro bass boat

Included is 1” plastic spaces with screws

Asking $35 Tyd
Paypal or Venmo ConUS only
Thanks for looking


Sent from my iPhone using Tapatalk

[Jig Man]

Hope you get her sold.  I had one in my Nitro. I did not like it so I took it off and sold it.

[Curt]

I'm assuming this has to be mounted in the deck, which requires cutting holes?

[Jig Man]

Nope.  It goes over the front of the recessed tray for the tmotor foot control.  I put a bridge on mine to hold the second unit up front so I did not need it.

[Curt]

Ah, OK. I don't know if that would work for me either. I'd have to check to see if I have enough extra space in front of my TM tray.

[Rhino81]

Jig man is right it mounts to the deck hovering above the tray. 

I was trying to use it on a non nitro boat and for me when mocking it up I couldn’t get it the way I wanted it


Sent from my iPhone using Tapatalk

[Rhino81]

I was using 1” spaces if the tray didn’t have the angled drop in front the clearance would’ve been better and it might have worked. 

So I’m going a different route to get a cup/tool holder

Also Price is OBO

Sent from my iPhone using Tapatalk

[Curt]

if the tray didn’t have the angled drop in front the clearance would’ve been better and it might have worked

I'm pretty sure mine has that same angle in the front.

[Curt]

So I’m going a different route to get a cup/tool holder

Be sure to let us know what you end up using. And show us some pics! 

[Rhino81]

Will do


Sent from my iPhone using Tapatalk