I worked on multiple items today!
The first was to reroute the power for my 798 to the new fuse block. It took me a while to dig that wire out from the place it had been hooked up by the dealer who installed it. But I got it done and then moved onto a few other various items.
Another one was to drill 4 new holes in the flange on my recessed trolling motor tray. For some reason, the factory only put one hole in the flange at the bottom end of the tray, right in the center. But none closer to the corners. So I drilled 4 new holes; 2 more on that bottom end flange, and 1 more on each side, close to the bottom corners.
I also hooked power up to my old 788 today so I could reset it to factory defaults and erase all of my waypoints so I can sell it.
Probably one of the biggest tasks was to put all of the tools away that I've been using for the last couple weeks.
I have been putting some away as I finished with them, but still had a fair number of them in the boat.
Only thing left is one more cup holder. Then it's time to load the rods back into the lockers and go fishing!