Well, I spent a couple hours working on my new trolling motor tray last night.
I'm about 3/4 of the way through it as of this morning. My old jigsaw decided to go up in smoke (literllay
) about half way through the cutting, so I had to run out and buy a new one.
I finished cutting the hole and I'm now working on removing the necessary flotation foam and doing some light filing of the hole in a couple spots to make sure the tray fits in there snug, but not too snug.
I'll be running out to grab the necessary screws, washers, etc. a bit later this morning so I can finish it up today and be able to test it out tomorrow during my tourney.
This pic shows the hole before it was completely done.
More pics to come when it's finished