Bass Boat Forums

Bass Boat Forums (by boat brand) => Skeeter Bass Boats Forums => Topic started by: Riverrock on January 23, 2015, 05:30:47 PM

Title: Welcome to BBB Skeeter room
Post by: Riverrock on January 23, 2015, 05:30:47 PM
First Skeeter post...test...
Title: Re: Welcome to BBB Skeeter room
Post by: Curt on January 23, 2015, 05:45:16 PM
Don't feel lonely. You'll have lots of company before too long :)
Title: Re: Welcome to BBB Skeeter room
Post by: bassfan73 on January 26, 2015, 09:31:33 PM
Here we come. 8)
Title: Re: Welcome to BBB Skeeter room
Post by: Curt on January 27, 2015, 02:39:12 PM
Let's see some pics, guys!!
Title: Re: Welcome to BBB Skeeter room
Post by: dog65 on September 03, 2018, 09:48:36 AM
Thanks for the welcome. I have an'07 Skeeter sx 170. Installed  new bilge and live well pumps recently.  the live  well timer was working before , but now the pump runs continuosly in the auto mode. Anyone know why this may be ?
Title: Re: Welcome to BBB Skeeter room
Post by: bullet20dc on September 03, 2018, 05:20:05 PM
first off welcome   I see you a yankee fan   you must be ok.
    your timer switch board is bad or the wiring is wrong   did u monkey around with it and undo the wires and possibly put em back on wrong

 or do u have one of them skeeters with a central computer that runs the whole boat.   if thats the case it would be a whole lot cheaper to run a new circuit from scratch.  just replaced a pooter in a fairly new skeeter and I seem to remember that part alone was around 800.00   thats the rear one on the rear stb side the one under the dash is BIG bucks
Title: Re: Welcome to BBB Skeeter room
Post by: Curt on September 04, 2018, 11:25:24 AM
As @bullet20dc said, it's more than likely a wiring issue, as in wires not connected properly after the pumps were replaced.

Oh, and welcome to BBB!  o/
Title: Re: Welcome to BBB Skeeter room
Post by: bullet20dc on September 04, 2018, 04:44:43 PM
got a msg from him  I wont go into it  but hes seen the light.  (yes) dog65  put up a pic of the switch u have front and back and Ill try and fix her up for ya  theres a ground wire going to the circuit maybe thats off.  usually black wire. but typically it goes  on a gang of male spade lugs usually the pump wires are brown (hot)  and black (gnd) there should be a 12v feed (red)or orange,  and pob an orange lead  timer feed going from timer side to on/off/timer  switch legs 
SimplePortal 2.3.6 © 2008-2014, SimplePortal