Bass Boat Forums
Buy - Sell - Swap => Boat Accessories For Sale => Topic started by: Rhino81 on August 16, 2018, 06:52:35 PM
-
Have a new unused Nitro Z bow/trolling motor tool and cup holder.
It wouldn’t work for my setup.
Part Number: 188896
Part Quantity: 1
Part Description : Cup/tool holder for nitro bass boat
Included is 1” plastic spaces with screws
Asking $35 Tyd
Paypal or Venmo ConUS only
Thanks for looking (https://uploads.tapatalk-cdn.com/20180816/4dda54a84d2fe5e22c3a545a469b6a8c.jpg)
Sent from my iPhone using Tapatalk
-
Hope you get her sold. I had one in my Nitro. I did not like it so I took it off and sold it.
-
I'm assuming this has to be mounted in the deck, which requires cutting holes?
-
Nope. It goes over the front of the recessed tray for the tmotor foot control. I put a bridge on mine to hold the second unit up front so I did not need it.
-
Ah, OK. I don't know if that would work for me either. I'd have to check to see if I have enough extra space in front of my TM tray.
-
Jig man is right it mounts to the deck hovering above the tray.
I was trying to use it on a non nitro boat and for me when mocking it up I couldn’t get it the way I wanted it
Sent from my iPhone using Tapatalk
-
I was using 1” spaces if the tray didn’t have the angled drop in front the clearance would’ve been better and it might have worked.
So I’m going a different route to get a cup/tool holder
Also Price is OBO
Sent from my iPhone using Tapatalk
-
if the tray didn’t have the angled drop in front the clearance would’ve been better and it might have worked
I'm pretty sure mine has that same angle in the front.
-
So I’m going a different route to get a cup/tool holder
Be sure to let us know what you end up using. And show us some pics! :nod:
-
Will do
Sent from my iPhone using Tapatalk