Bass Boat Forums
Electronics Forums => Lowrance Forum => Topic started by: phopkins38 on March 16, 2016, 10:59:48 PM
-
I have 2 HDS 7 Gen 2 with the LSS 2 mounted.One at the bow and one in the console. I had to do a factory reset and my Down Image screen capability went away and I cannot seem to get it back. I have sonar and side imaging. I use to have all three screens on the structure selection. I followed the install instructions again but no luck. Any help would be greatly appreciated.
-
Have you checked for firmware updates since you did that? Maybe that will help.
-
@Eric Low You run Lowrance units. Any ideas on this one?
-
It has been a few years since I had those units. Make sure you install the correct transducer I believe 800/400/83 hz. Sounds like it is just picking up 83. Do you have down scan on the TM or are the units linked? Neither unit works?
-
Here you go... https://www.youtube.com/watch?v=mAmAkP4w6mo
You have to reselect your tranducer type
-
@phopkins38 The info above from Eric and Jack should help you!
-
Thanks guys. I will check all that tomorrow.