Nitro Z bow/trolling motor tray tool/cup holder
by Rhino81 on 16 Aug, 2018 18:52
Have a new unused Nitro Z bow/trolling motor tool and cup holder.
It wouldn’t work for my setup.
Part Number: 188896 Part Quantity: 1 Part Description : Cup/tool holder for nitro bass boat
Included is 1” plastic spaces with screws
Asking $35 Tyd Paypal or Venmo ConUS only Thanks for looking
Sent from my iPhone using Tapatalk
Reply #1
by Jig Man on 17 Aug, 2018 07:32
Hope you get her sold. I had one in my Nitro. I did not like it so I took it off and sold it.
Reply #2
by Curt on 17 Aug, 2018 12:18
I'm assuming this has to be mounted in the deck, which requires cutting holes?
Reply #3
by Jig Man on 17 Aug, 2018 13:27
Nope. It goes over the front of the recessed tray for the tmotor foot control. I put a bridge on mine to hold the second unit up front so I did not need it.
Reply #4
by Curt on 17 Aug, 2018 13:31
Ah, OK. I don't know if that would work for me either. I'd have to check to see if I have enough extra space in front of my TM tray.
Reply #5
by Rhino81 on 17 Aug, 2018 14:36
Jig man is right it mounts to the deck hovering above the tray.
I was trying to use it on a non nitro boat and for me when mocking it up I couldn’t get it the way I wanted it
Sent from my iPhone using Tapatalk
Reply #6
by Rhino81 on 17 Aug, 2018 14:40
I was using 1” spaces if the tray didn’t have the angled drop in front the clearance would’ve been better and it might have worked.
So I’m going a different route to get a cup/tool holder
Also Price is OBO
Sent from my iPhone using Tapatalk
Reply #7
by Curt on 17 Aug, 2018 18:15
Quote
if the tray didn’t have the angled drop in front the clearance would’ve been better and it might have worked
I'm pretty sure mine has that same angle in the front.